I’m getting ready to install [...]

network
Nylaflow routing for Hidden Bellhorns

I’m getting ready to install the Nylaflow rudder cable conduit in the top of the wing, and need to make it the right shape so the cable lines up with the HIDDEN bellhorn which will be installed later. (I’m guessing that the plans’ cable routing to the exterior bellhorns is not ideal for the hidden type due to the different geometry). Since the right shape might be difficult to accurately preduct without the bellhorn in position for reference, I am thinking of doing the following: DO NOT micro the bent outer segment of the conduit into its channel while laying it into the wing. Later, when the bellhorn is mounted, remove some foam around that ‘loose’ section of conduit, bend it to align with the bellhorn end, and put some micro (or spray foam) in the space around the conduit to hold it in the correct position.
Is this what others are doing? If not, does anyone see any issues with this approach, or is there a better method that’s already being used?

Joe Polenek

http://forum.canardaviation.com/showthread.php?t=6973&goto=newpost

Read More!
Nylaflow routing for Hidden Bellhorns

I’m getting ready to install [...]

Comment for

I’m getting ready to install [...]



WP Theme & Icons by N.Design Studio
Entries RSS Log in